Trailer hitches and towing
A trailer hitch on a Prius is a receiver bolted to the car's rear frame so that something can be attached behind it. On this car the most common reason is not towing a trailer but carrying a bike rack or a cargo carrier. This page explains what is known, what is only an owner's report, and what has not been checked.
What Toyota says
One owner who fitted a hitch to a 2009 Prius (Gen 2) wrote in 2011: "Officially Toyota does not recommend any sort of towing with the Prius."[1] That is one person's statement about one generation, and it is not a quote from Toyota's manual. The wording in the owner's manuals for the later cars (Gen 3, Gen 4 and Gen 5) has not been read for this page, so the official position for those cars is not recorded here. A towing rating that appears on a retailer's page is not the same thing as a rating from Toyota.
Hitch rating is not car rating
The hitch in the owner's account was a Curt 1¼-inch Class I hitch (sold as U-Haul 24743 at about $135), which the same account describes as rated for 2,000 lb of towing and 200 lb of tongue weight.[1] That is the rating of the hitch. It says what the steel receiver can take; it does not say what the car is allowed to pull. The owner added that he thought one could "tow up to the Class I limit of 2000 lbs without a problem", while saying plainly that this was not Toyota's view.[1] Treat that as an opinion, not as a safe limit.
What fitting a hitch involved (Gen 2 owner's account)
The owner reported the following for a 2004-2009 Prius:[1]
- No drilling was needed; the hitch bolted to the same frame points as the stock tow loops, which were removed.
- Tools: a ratchet and socket set, a narrow flat-head screwdriver, a utility knife and a flashlight.
- It took about an hour working alone on the ground. He said two people and a lifted car would have been much easier.
- A slit had to be cut in the plastic under-skirt on the driver's side to clear the hitch.
- He advised avoiding a hitch whose tube bar runs fully across the back, because it can deflect tailpipe exhaust and deform the bumper; he said the maker had changed the design around 2007.
- He warned against a generic trailer-light kit or tapping the rear lights directly, which he said "may overload the circuit and blow the car fuses", and recommended a kit made for the Prius with overload protection.
Common uses
- A hitch-mounted bike rack. This was the stated purpose in the account above.[1]
- A cargo carrier or box that sits on the receiver.
- A small trailer. This is the use Toyota is reported not to recommend; see the notice at the top.
Before you fit one
- Find the towing and accessory section of the owner's manual for your car and year. If it says not to tow, believe it.
- Ask a Toyota dealer whether a hitch changes your warranty coverage; this page does not know.
- Check the weight of whatever you will carry, including the rack, against both the hitch rating and any limit in the manual.
- Use wiring made for the car, not a generic splice.
- Check that the exhaust and bumper clear the hitch, as the owner above warned.
Not yet covered
- Toyota's own words for Gen 3, Gen 4, Gen 5 and the Prius Prime and Prius v.
- Hitch part numbers for each generation, with sources.
- Which cars have factory tow loops and what they are rated for.
- Reports from owners of the later generations.